As with everything with this whole line of chillers, it’s all about being super cold. So whenever it comes to piping selection, you need to be able to have something that can manage the temperature itself, and then an insulation solution that’s going to prevent heat ingress, which can cause your chiller to be undersized. We would recommend either ABS, which is a type of plastic that there are products that come pre insulated, very easy to install. Copper is also another great one, or stainless steel. If you’re using copper or stainless steel, you’re definitely going to want to use a clamshell-type insulation over the top of it. Feel free, once again, to give us a call and we can recommend a specific type. Other than that, just think about preventing heat ingress and that’s going to save you a lot of trouble. Thanks so much for your time. I hope I was able to answer some questions that you might have had. Just to close out, I’d love to say that here at G&D, we specialize in customer service. We have twenty-four seven customer service technicians that are available if there is a problem with your unit. The cannabis industry is my specialty, so you’ll probably talk to me. We have the ability, and we have designed cannabis extraction facilities. We’ll be able to talk to you about optimizing your chilling solution by splitting up pull down. We’ll be able to optimize your facility with high temp chillers that can manage the solvent recovery side of things, or bring it all together into one chiller, whatever makes the most sense. We can drive down capital costs and also drive down operating costs by optimizing the whole solution. If you have any questions or want to talk about a solution that’s perfect for you and your facility, please feel free to give us a call or shoot us an email. Contact Us